- : Ms Word, Ms Word Format
- : 70 Pages
- : ₦3,000 | $25 | ₵60 | Ksh 2720
- : 1-5 Chapters
- Click to DOWNLOAD Materials
DESIGN AND CONSTRUCTION OF WATER LEVEL CONTROLLER
This project is titled the design and construction of a water level sensor system. It is designed to indicate the level of water to over-head tank.
The circuit uses the widely available CD4066, bilateral switch CMOS IC to indicate the water level through LEDs.
When the water is empty the wires in the tank are open circuited and the 180K resistors pulls the switch low hence opening the switch and LEDs are OFF. As the water starts filling up, first the wire in the tank connected to S1 and the + supply are shorted by water. This closes the switch S1 and turns the LED1 ON. As the water continues to fill the tank, the LEDs2 , 3 and 4 light up gradually.
The no. of levels of indication can be increased to 8 if 2 CD4066 ICs are used in a similar fashion.
When the water is full, the base of the transistor BC148 is pulled high by the water and this saturates the transistor, turning the buzzer ON. The SPST switch has to be opened to turn the buzzer OFF.
Title Page———i
Certification——–ii
Dedication———iii
Acknowledgement——-iv
Abstract ———vi
Table of Content——–vii
Chapter One
1.0 Introduction ——-1
1.1 Statement of Problem——4
1.2 Purpose of the Study——5
1.3 Significance of Study——8
1.4 Limitation——–9
1.5 Scope of Study——-11
Chapter Two
2.0 Review of Related Literature —-12
2.6 Summary of Literature Review—- 19
Chapter Three
3.0 Research Methodology and Procedure—22
3.1 Population ——–22
3.2 Sample and Sampling Technique—-22
3.3 Validation of the Instrument —-23
3.4 Reliability of the Instrument —–23
3.5 Data Analysis——-23
Chapter Four
4.0 Presentation and Discussion of Result—24
4.1 Analysis and interpretaion of Data—25
4.2 Discussion of Results——38
Chapter Five
5.0. Summary, Conclusion, and Recommendation –40
5.1 Summary——–40
5.2 Conclusion——–41
5.3 Recommendation——42
References ———45
Appendix 1——–47
Appendix ———50
