This project is titled the design and construction of an automatic water level controller system. It is designed to control flow and pumping of water to over-head tank.
The Water Level Controller System is an Electronic Equipment which when electrically connected to the starter of any given pump -set motor will control the operation of the pump- set depending upon the water level in the Source and Destination Storage Tanks. It Switches ON the Pump-set when Water level drops below pre-set level (i.e. T2 level) in Overhead Tank, Switches OFF the Pump-set when Water level in Overhead Tank becomes full (i.e. T1 level),Switches OFF the Pump-set when Water level is low in tank (i.e. S2 level), and Switches ON the Pump-set when there is sufficient water in the tank.
This work is aim at constructing an automatic water level controller that will control the flow and pumping of water in the overhead and underground tank which is controlled by 89c52 microcontroller.
Table of Content——–vii
1.0 Introduction ——-1
1.1 Statement of Problem——4
1.2 Purpose of the Study——5
1.3 Significance of Study——8
1.5 Scope of Study——-11
2.0 Review of Related Literature —-12
2.6 Summary of Literature Review—- 19
3.0 Research Methodology and Procedure—22
3.1 Population ——–22
3.2 Sample and Sampling Technique—-22
3.3 Validation of the Instrument —-23
3.4 Reliability of the Instrument —–23
3.5 Data Analysis——-23
4.0 Presentation and Discussion of Result—24
4.1 Analysis and interpretaion of Data—25
4.2 Discussion of Results——38
5.0. Summary, Conclusion, and Recommendation –40
DESIGN AND CONSTRUCTION OF A WATER LEVEL CONTROLLER USING MICROCONTROLLER