DESIGN AND CONSTRUCTION OF AN AUTOMATIC GATE

DESIGN AND CONSTRUCTION OF AN AUTOMATIC GATE

The project is titled design and construction of an automatic gate opener using infrared. Opening and closing of doors is always a tedious job, especially in places like shopping malls, hotels and theatres where a person is always required to open the door for visitors.
This project proposes a system of automatic opening and closing of door by using remote. The remote sensor transmitter emit infrared radiation  from a considerable distance and sends it to the receiver, commanding the receiver to either open the gate or to close it. This sensing signal is fed to a controller to operate a door motor through motor driver IC.
The remote sensor sends a logical command to open the door. The door automatically closes with a fixed time delay.

Title Page———i

Certification——–ii

Dedication———iii

Acknowledgement——-iv

Abstract ———vi

Table of Content——–vii

 

Chapter One

1.0 Introduction ——-1

1.1 Statement of Problem——4

1.2 Purpose of the Study——5

1.3 Significance of Study——8

1.4 Limitation——–9

1.5 Scope of Study——-11

 

Chapter Two

2.0 Review of Related Literature —-12

2.6 Summary of Literature Review—- 19

 

Chapter Three

3.0 Research Methodology and Procedure—22

3.1 Population ——–22

3.2 Sample and Sampling Technique—-22

3.3 Validation of the Instrument —-23

3.4 Reliability of the Instrument —–23

3.5 Data Analysis——-23

Chapter Four

4.0 Presentation and Discussion of Result—24

4.1 Analysis and interpretaion of Data—25

4.2 Discussion of Results——38

 

Chapter Five

5.0. Summary, Conclusion, and Recommendation  –40

5.1 Summary——–40

5.2 Conclusion——–41

5.3 Recommendation——42

References ———45

Appendix 1——–47

Appendix ———50

DESIGN AND CONSTRUCTION OF AN AUTOMATIC GATE

 

Sharing is caring!